Start installation
Preparation before installation
Read the requirements for
electric connection
Select installation location Prepare tools
Select indoor unit
installation location
Select outdoor unit
installation location
Install wall-mounting frame,
drill wall holes
Connect pipes of indoor unit
and drainage pipe
Connect wires of
indoor unit
Bind up pipes and hang
the indoor unit
Install the support of
outdoor unit
(select it according to the
actual situation)
Fix outdoor unit
Make the bound pipes pass
through the wall hole and then
connect outdoor unit
Install drainage joint of
outdoor unit (only for cooling
and heating unit)
Connect pipes of outdoor unit
Connect wires of outdoor unit
Neaten the pipes
Vacuum pumping and leakage detection
Check after installation and test operation
Finish installation
Note: this flow is only for reference; please find the more detailed installation steps in this section.
To Next Page
Loading...
