42
Settings
The procedure for changing the settings is as follows:
앫 The settings have a fixed sequence and are displayed consecutively,
see illustration on the previous page.
앫 Press the S button to call up the settings.
A test strip is not advanced.
앫 Press the M button to change the setting that is currently flashing.
쐍 Numbers such as the year are incremented by one. Pressing and
holding down the button increments the number quickly.
쐍 From the highest selectable number, pressing the M button auto-
matically takes you to the lowest one.
쐍 In the case of settings where there are a number of options, such
as the beep tone setting, pressing the M button presents each
option in turn.
앫 Press the S button to save the chosen setting and move on to the
next setting.
앫 You can change any setting at any time. Press the S button repeat-
edly until the setting you wish to change is displayed flashing.
AC_CP_LCM_Manual_EN-UK final.indd 42_CP_LCM_Manual_EN-UK final.indd 42 20.6.2007 11:04:0320.6.2007 11:04:03
To Next Page
Loading...
Need help?
General
