43
Settings
3
앫 From the last setting “Hypo indicator” pressing the S button takes
you back to the first setting “Beep tone/Acoustic Mode”.
앫 You can close the settings at any time by pressing the Test button.
All settings you have entered up to that point are saved.
Notes
i
Always turn the meter on with the S button when you intend to
change the settings.
Instead, if you turn the meter on with the Test button and there is
a drum in the meter, a test strip will be advanced.
i
If you turn the meter off with the Test button, it shows you the
number of test strips remaining in the drum (see Chapter 2.3.2).
i
The meter turns off automatically after approximately 60 seconds
if you do not press a button. All settings you have confirmed up to
that point with the S button are retained. Settings that you have
not confirmed with the S button are lost and the original setting
remains.
AC_CP_LCM_Manual_EN-UK final.indd 43_CP_LCM_Manual_EN-UK final.indd 43 20.6.2007 11:04:0320.6.2007 11:04:03
To Next Page
Loading...
Need help?
General
