75
Testing blood glucose
5
If the numbers are not the same:
did you really insert the code chip that came with the container of test
strips you are using? If the answer to this is yes, please contact your
local customer support and service centre (see Chapter 19).
After the code number has been displayed, you see the test strip symbol
with a flashing blood drop. When the beep tone is turned on, the meter
beeps at this point. The meter is ready to perform a blood glucose test.
If you wish to test blood glucose now, proceed to Chapter 5.3.
Note
If you missed the code number, push the test strip ejector (see
Chapter 5.4) down to eject the test strip, and then re-insert it.
To Next Page
Loading...
Need help?
General
