Accu-Chek GO - Changing Settings - General Rules

29
Entering settings
3
3.2.1 Changing settings – General rules
When set-up is displayed, it indicates that the meter is in one of the two
set-ups and you can change settings.
The following rules apply when you change settings:
O The setting currently flashing can be changed using the < and >
buttons.
J Pressing the < button decreases a number such as the year by
1, pressing the > button increases it by 1. Pressing and holding
down either button increases or decreases the number quickly
one digit at a time. When you change the target range setting
(See Chapter 3.2.6), the number initially changes by 1, then by a
value of 10 at a time.
J From the highest selectable value, pressing the > button auto-
matically takes you to the lowest; from the lowest selectable
value, pressing the < button takes you to the highest. An
exception to this is the target range setting (see Chapter 3.2.6).
J Settings that provide a number of options, such as the beep tone
setting, can be changed from one option to the next with the <
and > buttons.
J Once you have started Quick set-up, pressing the < and >
takes you from one group to the next, e.g. from F 1 to F 2 or vice
versa.