Select the control solution to
test. You will confirm the
level later in the test.
4
Remove the bottle cap. Wipe
the tip of the bottle with a
tissue. Squeeze the bottle
until a tiny drop forms at the
tip.
5
Touch the drop to the yellow
edge of the test strip. Do not
put control solution on top of
the test strip.
6
Insert the metallic end of
the test strip into the meter.
Place the meter on a flat
surface.
3
The meter turns on.
A flashing drop symbol
appears.
1080_Guide Me_MANUAL_MASTER.indb 27 3/5/2018 1:27:52 PM
To Next Page
Loading...
