Transferring Data Using a USB Cable
This feature allows you to transfer data from your meter to special software for diabetes management on
a PC using a USB cable.
Plug the small end of the
USB cable into the meter.
1
Plug the large end of the USB
cable into a USB port on the PC.
If the meter is o, it turns on.
2
Start the diabetes
management software on
the PC and initiate a data
transfer.
3
The meter transfers the data
to the software.
4
NOTE
The USB cable does not charge the meter’s batteries. Remove the
USB cable after you have finished.
1080_Guide Me_MANUAL_MASTER.indb 39 3/5/2018 1:27:58 PM
To Next Page
Loading...
