Accu-Chek Guide Me

26
Control Tests
4
Performing a Control Test
NOTE
• Most people just test the Level  1 control. If you wish, you can also test a Level  2 control. A set of
Level  1 and Level  2 control solutions is available for purchase.
• The ranges for Level
 1 and Level  2 controls are printed on the test strip container label.
• The meter turns o 90seconds after a successful test or 15seconds after the test strip is removed,
provided no other action is taken.
You need the meter, a test strip, and control solution Level 1 or Level 2.
Check the Use By date on
the test strip container. Do
not use test strips past the
Use By date.
Remove a test strip from the
test strip container.
Close the cap tightly.
1 2
1080_Guide Me_MANUAL_MASTER.indb 26 3/5/2018 1:27:51 PM