Accu-Chek Guide Me User Manual

52
Meter Maintenance and Troubleshooting
8
(The error code and Err will alternate on the display.)
The time and date setting may be incorrect. A
flashing wave symbol appears while the meter
attempts to synchronize the time and date with
the paired device.
When the wave symbol no longer appears, press
the power/set button to turn the meter o. Press
the power/set button a second time until the
flashing test strip symbol appears. If time and
date sync was not successful the meter prompts
you to set them the next time you turn it on. See
the Setting the Time and Date section in the
chapter Your New System.
(The error code and Err will alternate on the display.)
The batteries are almost out of power.
Change the batteries now. If the message
reappears after the batteries have been replaced,
remove the batteries again, press and hold the
power/set button for at least 2 seconds, then
reinsert the batteries.
1080_Guide Me_MANUAL_MASTER.indb 52 3/5/2018 1:28:04 PM

Accu-Chek Guide Me Specifications

General

Display	LCD
Sample Size	0.6 µL
Test Time	Less than 4 seconds
Connectivity	Bluetooth
Measurement Range	10 to 600 mg/dL
Battery Type	2 x CR2032 3V lithium coin cells
Battery Life	Approximately 1000 tests
Weight	40 g (1.4 oz) with battery
Storage Conditions	-25°C to +70°C (-13°F to +158°F)