User Manual The Keypad 5-3
How to set the relay time (First Relay)
Note: The relay time is factory set to 15 seconds
by Accutech.
To change the relay time:
1. Enter the installer code [1][1][1][1][*] to
enter program mode. You will hear two
beeps.
2. Enter [4][0] then the desired relay time
(1-999 seconds), then the [#] key.
You will hear two beeps.
3. Enter [*] to exit program mode and
return the Keypad normal operation
mode.
(enter programming mode)
(selects timer for relay 1)
(sets timer to 15 seconds)
(exits programming mode)
To Next Page
Loading...
