What to do if the low fire switch is stuck on Ace Heating Solutions Boiler?
If the low fire switch is stuck ON in your Ace Heating Solutions Boiler, reset the module. If the fault repeats, further assistance may be needed.
What does unconfigured safety data mean on Ace Heating Solutions Boiler?
If your Ace Heating Solutions Boiler shows unconfigured safety data, complete the device configuration and safety verification. If the fault repeats, further assistance may be needed.
What does waiting for safety data verification mean on Ace Heating Solutions Boiler?
If your Ace Heating Solutions Boiler is waiting for safety data verification, it could be because the device is in configuration mode and safety parameters need verification, and the device needs a reset to complete verification. Alternatively, the configuration might have ended without verification; in this case, re-enter configuration, verify safety parameters, and reset the device to complete verification. If the fault repeats, further assistance may be needed.
What does internal fault hardware fault mean on Ace Heating Solutions Boiler?
If your Ace Heating Solutions Boiler shows an internal hardware fault, reset the module. The cause is an internal fault. If the fault repeats, further assistance may be needed.
What does main relay feedback incorrect mean on Ace Heating Solutions Boiler?
If your Ace Heating Solutions Boiler displays 'Main relay feedback Incorrect', reset the module. The cause is an internal fault. If the fault repeats, further assistance may be needed.
What does internal fault A2D mismatch mean on Ace Heating Solutions Boiler?
If your Ace Heating Solutions Boiler shows an internal fault A2D mismatch, reset the module. The cause is an internal fault. If the fault repeats, further assistance may be needed.
What causes the low fire switch to be off on Ace Heating Solutions Boiler?
If the low fire switch is off on your Ace Heating Solutions Boiler, reset the module. The cause is an internal fault. If the fault repeats, further assistance may be needed.
What causes the high fire switch to be off on Ace Heating Solutions Boiler?
If the high fire switch is off on your Ace Heating Solutions Boiler, reset the module. The cause is an internal fault. If the fault repeats, further assistance may be needed.
What causes the interrupted airflow switch to be off on Ace Heating Solutions Boiler?
If the interrupted airflow switch is off on your Ace Heating Solutions Boiler, reset the module. The cause is an internal fault. If the fault repeats, further assistance may be needed.
What to do if the Ace Heating Solutions Boiler demand is lost in run?
If the demand is lost during a run in your Ace Heating Solutions Boiler, first check for an adequate gas supply at the gas inlet. Then, remove the UV flame detector and clean the lens using a soft cloth. If these steps don't resolve the issue, further assistance may be needed.
General| Model | Atlas A050 |
|---|---|
| Category | Boiler |
| Manufacturer | Ace Heating Solutions |
| Fuel Type | Natural Gas |
| Mounting | Wall-Mounted |
| Output | 50, 000 BTU/hr |
| Efficiency | 95% |
To Next Page