AcerPower Minitower (M11E/IDCATX-2) User's Guide
xxxviii
Chapter 2 BIOS Utility
Most systems are already configured by the manufacturer or the dealer. There is no need
to run Setup when starting the computer unless you get a Run Setup message.
The Setup program loads configuration values into the battery-backed nonvolatile memory
called CMOS RAM. This memory area is not part of the system RAM.
If you repeatedly receive Run Setup messages,
the battery may be bad. In this case, the system
cannot retain configuration values in CMOS.
Ask a qualified technician for assistance.
2.1 Entering Setup
To enter Setup, press the key combination + + .
You must press + +
while the
system is booting. This key combination does not
work any other time.
The Setup Utility Main Menu appears:
To Next Page
Loading...
