ACT ACTPRO 4000 - TCP;IP Settings; IP Address; Default Gateway; Network Speed

ACTpro 4000 Operating Instructions 1.00
__________________________________________________________________________
Network Mask
Sets the Network Mask.
Default Gateway
Set the default gateway (also known as default route).
MAC Address
Displays the MAC address.
NetBIOS Name
Displays the NetBIOS name.
Network Speed
Set the ACTpro 4000 IP network speed.
Enable DHCP
Enable DHCP operation.
Central/Sat Central Server
Enable/Disable ACTpro 4000 as Central Server.
Central IP Addr
Set the IP address of the Central Server.
Card Setup Site Code 1
Enter the primary site code for the system.
Site Code2
Enter a secondary site code for the system.
Card Format
Enter a custom card format for the system.
Diagnostics Version
Displays the current software version.
Reader test
Reads a card and displays the received information.
Voltage Check
Display voltage supplied to ACTpro 4000.
Factory Diag
For Factory Use only. – Do not use.
Last Reset
Displays a code indicating the reason for the last reset.
Change PIN
Change the PIN used to access the Installer menu.
Factory Defaults
Restore the system to its factory default settings.
*
First it is required to select a door.
Exit from menu is automatic if no keys are pressed for a period of time.
__________________________________________________________________________________
19