ACTpro 4000 Operating Instructions 1.00
__________________________________________________________________________
__________________________________________________________________________________
30
Once the card has been presented, the display will update. The top line shows the number of
bits of data followed by the type of data (C for “Clock and Data” or W for “Wiegand”),
followed by the number of digits on the card, followed by a slash "/", followed by the last 10
digits read from the card.
If the data the on the card matches the ACT site code format then second line will display the
Card data in the ACT Site, otherwise it will display data as read from the card.
Example: 32-bit Wiegand Card Data:
32W10/0915265139
0915265139
Voltage Check
This menu displays the voltage supplied to the ACTpro 4000 +12V terminals.
Last Reset
This menu may be used by ACT technical support.
Change PIN
The Change PIN function allows a different PIN to be configured for the installer. The user
will be prompted to enter a new six-digit code (it will not be displayed). The PIN must then be
re-entered for verification. The PIN will be accepted as long as it does not conflict with any
existing code (or duress code).
Factory Default
This function returns all settings to the factory default. All user names, time zones, card
enables, log information and Operator and Installer Code an all other settings are defaulted.
All information previously programmed will be lost, so use this function with care.
In situations where the Installer Code is unknown the Controller may be defaulted as follows:
Hold down the key while powering up the Controller, when requested for a Site Code enter
the ACT default Site Code 10-2770-09, finally when asked to default controller hit the key
to default. It is always a good idea to factory default a new controller prior to initial
configuration, or if the controller software has been changed or upgraded.
To Next Page
Loading...
