200S ix
Table of Contents
200S Key Layout........................................................................................................i
200S Soft keys...........................................................................................................i
Readout Parameter Access Code
Access to Machine Parameter Operations ..............................................................iii
Introduction
Software Version ......................................................................................................v
200S
DRO axis availability...........................................................................................v
Symbols within Notes...............................................................................................v
200S Fonts................................................................................................................v
Hassle-Free Warranty
3-Year Hassle-Free Warranty.......................................................................................vii
I - 1 Fundamentals of Positioning
Datums .................................................................................................................... 2
Actual Position, Nominal Position, and Distance-To-Go........................................... 2
Absolute Workpiece Positions................................................................................. 3
Incremental workpiece positions............................................................................. 3
Zero Angle Reference Axis ...................................................................................... 4
Reading head position ............................................................................................. 4
Encoder Reference Marks ....................................................................................... 5
I - 2 General Operations for 200S
Screen Layout.......................................................................................................... 6
General Navigation................................................................................................... 7
Power Up................................................................................................................. 7
Reference Mark ....................................................................................................... 8
Working without reference mark........................................................................ 9
Enable/Disable Ref function................................................................................ 9
Operating Modes................................................................................................... 10
Setup .................................................................................................................... 11
Job Setup Parameters ........................................................................................... 11
Units.................................................................................................................. 11
Scale Factor ...................................................................................................... 12
Mirroring a part ................................................................................................. 12
Edge Finder (milling applications only).............................................................. 12
Diameter Axes .................................................................................................. 13
To Next Page
Loading...
General