No rainfall
• Check to ensure the rain gauge stabilizer (plastic tab) has been removed
from the bottom of the sensor (see page 7).
• Clear debris, such as leaves, out of the rain collector funnel and debris s
creen.
• Calibrate the Rain Gauge (see page 23).
Inaccurate wind readings
• What is wind reading being compared to? Pro weather stations are typi
cally mounted at 30 ft high or more. Make sure to compare data using a
sensor positioned at the same mounting height.
• Check the location of the sensor. Ensure it’s mounted a minimum of 5 ft i
n the air with no obstructions around it (within several feet).
• Ensure wind cups are spinning freely. If they hesitate or stop try lubricati
ng with graphite powder or spray lubricant.
USB connectivity not working
• Verify display is in USB mode 3 (see page 13).
• Unplug USB from display to computer for 20 seconds and then plug back
in.
• Check that the batteries are installed correctly. Batteries may need to be
replaced.
• Reset the display by pressing the reset button, located on the back of th
e display. The date and time will need to be entered after a reset.
Display screen not working
• Check that the batteries are installed correctly. Batteries may need to be
replaced.
• Reset the display by pressing the reset button, located on the back of th
e display. Date and time will need to be entered after a reset.
To Next Page
Loading...
