- 19 -
Confirming or Altering Audio & Video Links & Changing Input Label Names
Before proceeding with verification and alteration of Audio/Video Links per Input Label, please
be advised that even sources which do not have a video output will need to be linked to a
video input. If you have open video inputs, you may choose to link the audio from these
audio-only sources to an open video (providing that link is available in the SSD-66 (5.1)'s A/V
Link). Otherwise, simply link the audio to the video of another source. This will become clear
as we proceed with the setup.
Step 1 Repeatedly press the INPUT SELECT button until the SSD-66 (5.1)'s display reads the appropriate
Input Label. The list below indicates the factory default Input Label names and the corresponding
Input Numbers.
LASER AC3 1 LASER PCM 2 TV/CABLE 3
VCR 4 SATELLITE 5 CD PLAYER 6
TUNER 7 MULTIROOM 8 GAMES 9
CAMERA 10 DVD 11 CASSETTE 12
AUX ONE 13 AUX TWO 14
DTS Note: When using a DTS-1 with a six source system (see page 20), ADA suggests rewriting Input Label #3
(typically "TV/CABLE") as "LASER DTS". This will involve moving the "TV/CABLE" Input Label to
another Input number. Please note, that only the first 8 input labels can be directly accessed from
the SSD-66 (5.1) IR remote control. If you are using DTS in a five source system (see page 22),
ADA suggests rewriting Input Label #7 (typically "TUNER") as "DTS MUSIC". "DTS MUSIC" will
have the SSD-66 (5.1)'s Re-EQ filter in the off position (discussed under Acoustical Parameters)
where it should be normally on in the "LASER DTS" Input Label.
Step 2 Repeatedly press the SETUP MODE button until the display reads either "MUTI PIN/V#", "OPTI-
CAL/V#", "DIGITAL#/V#", or "ANALOG#/V#". The "#" refers to either Digital Audio Input number,
Analog Audio Input number, and the Composite Video Input number.
Step 3 Using the VOL UP and VOL DN buttons to advance through the SSD-66 (5.1)'s available audio and
video links until the correct A/V Link is displayed. (The list of available links is printed on page 14.)
Step 4 If you do not need to change the Input Label Name, skip to Step 8. If you want to change how the
Input Label reads, repeatedly press the SETUP MODE button until the display reads "LABEL IN-
PUTS". The SSD-66 (5.1) will exit the "Setup Mode" automatically if no other buttons are pressed
(automatic time-out function).
Step 5 Press the "ALL" button to engage the character cursor. A letter on the SSD-66 (5.1)'s display will
begin to flash.
Step 6 Use the CENTER and REAR buttons to advance the cursor right and left (respectively) until the
cursor flashes the first letter you wish to alter.
Step 7 Use the RIGHT and LEFT buttons to scroll up and down (respectively) through alphanumeric char-
acters, symbols, and numbers. When the correct character appears, press the CENTER or REAR
button to advance to the next character and continue changing the next character using the RIGHT
and LEFT buttons. Please note, you can only change the first nine characters. The remaining three
characters refer to the input number (and a space) which are fixed. When name appears as you
with it to, proceed to the next step.
Step 8 Press the INPUT SELECT button again. This will exit the "Setup Mode". If you have changed an
Input Label Name, the change will also be stored.
Step 9 Press the INPUT SELECT button one more time to advance the SSD-66 (5.1) to the next Input
Label.
Step 10 Repeat Steps 2-9 for all additional Input Labels.
To Next Page
Loading...
