adept technology Lynx Platform - Page 30

Adept Lynx Platform User's Guide, Rev D
Page 30 of 126
Chapter 2: Setup
The following applies to the wireless Ethernet supported by the Adept Lynx platform.
Access the SetNetGo OS through the MobilePlanner software:
MobilePlanner >SetNetGo >Networking
NOTE:It is also possible to connect directly to the SetNetGo OSon a platform
through a web browser. The main intent of this is to allow your IT support to set up
the network for you, without using MobilePlanner, which requires a license.
IP Address, Netmask, Gateway, DNS1
Choose Static (DHCP is not recommended), and fill in the IP address, netmask, gateway, and
DNS1, as supplied by your network administrator.
NOTE:The following settings have to be provided by your IT department.
Radio Settings
l
SSID (e.g. AGV)
Fill in the appropriate wireless SSID for your wireless network.
The SSID is case sensitive.
l
Mode
Managed/STA, Ad-Hoc, or Master/AP
l
Radio Mode
Auto, 802.11a, 802.11b, 802.11g
l
Channel Set
l
Wireless Watchdog IP Address
l
Wireless Watchdog Max Count
0 disables this.
Security Settings
Encryption:
l
Disabled
l
WEP 64-bit
l
WEP 128-bit
l
TKIP/RC4
l
CCMP/AES
l
TKIP/CCMP/AES