GB 02451 - Edition 01 - March 04
3/5
B 100
Alcatel Vacuum Technology France - ATH 200 User’s Manual
Safety instructions
Other located hazardous energies: Nitrogen purge,
pressurized hazardous energies. Release pressure before
servicing, disconnect the gas line quick connector and turn off
the pressure regulator by turning the knob counter-clockwise.
Operating conditions may generate
temperatures justifying particular
attention on the part of the user
(external surfaces > 70°C on
exhaust connections).
Contact may cause burns.
Always use gloves before servicing.
Pump labels
Leak detector labels
Located near the main power switch, this label indicates that after
disconnecting power supply, the operator should wait 5 minutes
before working on the leak detector.
Located near the main power switch, this label indicates that the
product has been customized in factory, according to customer order.
Located at the top of the frame, near the exhaust port, this label
indicates that the exhaust port should not be blocked.
Located on the rear of the pump, this label warns the user against
possible risk of injury due to any hand contact with hot surfaces.
It states that protective gloves should be used before performing any
intervention.
Located on the upper cover, this label indicates that due to its heavy
weight, the product should not be handled manually, but always
through appropriate handling devices.
Located on the upper cover, this label indicates that some of the
internal parts are energized and could cause electrical shocks in case
of contact. It advizes to disconnect the pump before any intervention
or to properly lock-out and tag-out the equipment breaker before any
intervention on the pump.
To Next Page
Loading...
