GB 00986 - Edition 06 - February 05
1/3
General contents
ASM 182 TD+ - ASM 192 TD+ -
ASM 192 T2D+ User’s Manual
MANUAL REFERENCE: 109229
EDITION: 07- January 2006
Software version:
L115 v3.0 r.01 (ASM 182 TD+)
L116 v3.0 r.01 (ASM 192 T2D+)
L132 v3.0 r.01 (ASM 192 TD+)
Chapter A INTRODUCTION
A 100 - Introduction to the ASM 182 / 192 series
A 200 - ASM 182 TD+ / 192 TD+ - Detector operating principle
A 201 - ASM 192 T2D+ - Detector operating principle
A 300 - Analyzer cell operating principle
A 400 - Testing methods
A 401 - About Helium and hydrogen
A 500 - Operator interface: control panel
A 501 - Operator interface: control panel
A 600 - Options
A 700 - Accessories
A 800 - ASM 182/192 TD+ - Technical characteristics
A 801 - ASM 192 T2D+ - Technical characteristics
A 900 - ASM 182 TD+ - Dimensions
A 901 - ASM 192 series - Dimensions
Chapter B INSTALLATION
B 100 - Safety instructions
B 110 - Unpacking - Storage - Transportation
B 200 - Neutral gas purge and inlet vent connection
B 210 - ASM 182 - Connecting the detector to the installation
B 211 - ASM 192 - Connecting the detector to the installation
B 300 - Controlling the detector with the I/O interface
B 310 - Controlling the detector with a PC computer through the RS 232 interface
B 320 - Connecting the detector directly to a printer or another device
B 400 - ASM 182 series - Before starting up the leak detector
B 401 - ASM 192 series - Before starting up the leak detector
Chapter C OPERATION
C 100 - Factory configuration of the leak detector parameters
C 110 - Operating principle of the control panel
C 120 - Setting and maintenance part presentation of the control panel
C 130 - Access to level
- Password
C 140 - Summary of screens
C 200 - Starting up / Switching off the leak detector
C 210 - How to use the leak detector: 2 test modes
C 211 - Operation of the leak detector
C 300 - Calibration of the leak detector
C 301 - Basic internal calibration of the leak detector
C 302 - Advanced internal calibration of the leak detector
C 303 - External calibration of the leak detector
C 304 - Correction factor
C 305 - Calibrated leak values programming
C 306 - Adaptator for calibrated leak
C 400 - Remote control
C 410 - Headphone and loudspeaker
C 420 - Gas line (option) ASM 182 TD+
C 430 - 3 masses option
C 440 - Control panel with graphic interface
C 450 - Long distance sniffer probe and Helium spray gun
Preliminary
remarks
Throughout this User’s Manual, you could find this type of message
“Summary of screen
C 140”: it refers to a specific chapter of the
User’s Manual. Please read it for further information.
To Next Page
Loading...
