ADLINK Technology arm AMPERE COM-HPC-ALT

To Next Page

To Previous Page

COM-HPC-ALT User’s Guide PICMG COM-HPC R1.0

2.4 Multi I/O and Storage

USB

Up to 4x USB 3.2 Gen1/2.0 (USB 0,1,2,3; via PCIe to USB IC) (the IC is Renesas uPD720201)

SuperSpeedPlus, SuperSpeed, High-Speed, Full-Speed and Low-Speed USB signalling

Asynchronous Serial Port

Two UART interfaces UART0 and UART1. UART0 supports TX RX RTS CTS. UART1 supports TX/RX

Console Redirection UART0 or UART1 selectable in BIOS

Up to 2 serial ports are supported in standard BIOS including Super I/O on the carrier

COM Port Description IRQ Address Console Redirection Support

COM 1 Supported by module (SER0, A98/A99), via SOC 4 0x3F8 Yes

COM 2 Supported by module (SER1, A101/A102), via SOC 3 0x2F8 Yes

Note: UART0, 1 both source from SOC. UART0 offers TX, RX, RTS#, CTS#. UART1 only offers TX and RX; its RTS#, CTS# are simulated by 2 GPIO

from SOC.

GPIO

12x GPIO

Supports GPI with interrupt

ADLINK Technology arm AMPERE COM-HPC-ALT - Multi I;O and Storage