ADLINK Technology arm AMPERE COM-HPC-ALT - Additional Features

72 pages

Save Page as PDF

To Next Page

To Previous Page

COM-HPC-ALT User’s Guide PICMG COM-HPC R1.0

5. Additional Features

This chapter describes the connectors, LEDs, and switches, located on the module and are not necessarily included in the PICMG standard specification.

The locations of these parts are as shown below:

BIOS

Default

Reset

Fan Connector

40-pin

Debug

Connect

Main Page

Revision History2
Preface3
Table of Contents8
Introduction11
Specifications12
Core System12
Expansion Busses13
Ethernet16
Multi I/O and Storage17
Others18
Security18
Module Management Controller (MMC)19
Debug25
Power25
Mechanical and Environmental26
Block Diagram28
Figure 1 - Module Function Block Diagram28
Pinout and Signal Descriptions29
Pin Summary29
Figure 2 - Module Rear Side Row29
Signal Terminology Descriptions36
Signal Descriptions on J1/J2 Connectors37
Ethernet KR/KX37
NBASE-T Ethernet38
PCI Express40
Usb47
Asynchronous Serial Port49
I2C50
Port 80 Support on USB_PD I2C Bus51
Ipmb51
General Purpose SPI52
Power & System Management53
Thermal Protection54
Smbus55
General Purpose Input Outputs55
Module Type Definition56
Miscellaneous Signals57
Power and Ground59
Additional Features60
Debug Connector (40-Pin Connector)61
Status Leds62
Fan Connector63
BIOS Default Reset64
BIOS Boot Select65
BIOS Checkpoints, Beep Codes66
Status Code Ranges67
Mechanical and Thermal68
Module Dimensions68
Thermal Solutions69
Heatsink : THS-ALT-BL69
Figure 4 - Heatsink THS-ALT-BL69
Low Profile Active Cooler: THSF-ALT-BL-S70
Figure 5 - THSF-ALT-BL-S70
High Profile Passive Heatsink: THSH-ALT-VC71
Figure 6 - High Profile Passive Heatsink THSH-ALT-VC71
Active Cooling: THSF-ALT-BL72
Figure 7 - Cooler THSF-ALT-BL72

ADLINK Technology arm AMPERE COM-HPC-ALT - Additional Features

Table of Contents

Related product manuals