Adtech NCT-04 User Manual

NCT-04/03/02 Punch CNC System (Commissioning Manual)
17.Press the operating mode selection key
and switch to automatic operating mode;
18.Press
to run the program, start indicator is lit, and the program begins running.
19.Press Reset directly if exception occurs during running, and the system will reset and
continue processing; Repeat steps 4-18;
20.If the program aborts, press [Punch Lock] in the next processing to locate the punching until the
position that operation was aborted, and then cancel punching lock;

Adtech NCT-04 Specifications

General

Brand	Adtech
Model	NCT-04
Category	Control Systems
Language	English