Advanced Control C220 Series - Page 92

Parameter Description
C220/C420G General Flux Vector Control Inverter User Manual
91
setup
value
function description
parameters are all in the memory status, such as
PLC parameter, swing frequency parameter and
PID parameter. After this signal disappears, the
inverter restores to the status before stopping.
11
External fault
normally open
input
After the external fault signal is sent to the inverter,
the inverter reports fault and stops.
12
MS speed
terminal 1
It can realize 16S speed through the combination of
digital status of these four terminals. Refer attached
table 1 for the MS speed function description.
13
MS speed
terminal 2
14
MS speed
terminal 3
15
MS speed
terminal 4
16
Speed-up/speed-
down time
selection
terminal 1
It can select four types of speed-up/speed-down
time through the combination of digital status of
these two terminals.
Refer to table 2.
17
Speed-up/speed-
down time
selection
terminal 2
18
Frequency source
switching
When the frequency source selection (F0-10) is set
to
2, it performs switching between main frequency
source X and auxiliary frequency source Y via this