43
Instrument Operation
0. Select Setup Item
This menu item is displayed first when SETUP is pressed and allows
either direct selection or sequential selection of a menu item.
• Direct Selection: For direct selection, press START at Select Setup
Item. The display will change to Setup Menu #: 0. At Setup Menu
#: 0, enter the number of the desired setup item (from the Setup
Menu, Table 3) on the keypad and press ENTER. The display will
change to the selected menu item.
• Sequential Selection: For sequential selection, repeatedly press the
> switchpad to step the display forward or < to step the display
backward through the setup menu list. The displayed parameter
list is cyclic; pressing > at the last item cycles the display to item 0.
Continue pressing > or < until the desired menu item is displayed.
Note that while direct, numerical selection is only available at Select
Setup Item, > or < stepping is available from any menu position.
When the desired menu item is displayed, press the START switchpad
to select the item, display the current setting and enable changing the
setting.
The current setting is indicated either by the symbol * or a numeric
value and may be changed by pressing > or < (or using the item-
specific instructions below).
Press ENTER to store a new setting (or STOP to restore the original
setting). The display will revert to the title of the parameter selected.
Then one may press: START to display the new setting, > or < to step to
the next SETUP item, STOP to exit the SETUP menu, or TEST to change
to the TEST menu.
To Next Page
Loading...
Need help?
General
