Advanced Poly-Packaging T-1000 - Chapter 5: Parts

76
Preventative Maintenance Checklist
CHART
ITEM DESCRIPTION PERIOD
Filter / Air regulator
Drain water from filter
D
Air regulator
Adjust pressure to 60 PSI
D
Anti-jam device
Check operation, adjust as needed (section 4.11)
D
Pressure bar (rubber)
Clean with alcohol
D
Perforation sensor
Clean sensor assembly with alcohol
W
Upper (rubber) roller
Inspect for nicks or cuts; clean with alcohol
W
Lower (alum.) roller
Clean with alcohol
W
Micron filter / Ventura
Inspect for contamination of filter, replace as needed
Inspect for blockage / air restriction
M
Wiring / Connectors
Inspect for loose wiring / connectors, tighten as needed
M
Air lines / Valves /
Cylinders
Inspect for loose air lines, listen for leaks, tighten or replace
poly tubing as needed
M
Compartments / Covers
Remove all covers, clean and blow out compartments with
compressed air to remove dust and dirt
M
Side-plates
Clean and wipe down with lightweight oil (based upon
environmental humidity conditions)
M
Drive belt
Inspect for wear / fraying, replace if needed
M
Drive belt (right panel)
Inspect for looseness, tighten as required
M
Touch screen cabinet /
arms
Tighten set screws
M
Height adjustments screws
Tighten bolts
M
CAUTION: Unplug power cord and disconnect air line prior to removing guards, funnels or covers.
Preventative maintenance must be performed by qualified maintenance personnel.
Legend for Preventative Maintenance Checklist:
D
Daily
W
Weekly
M
Monthly