49 Chapter 4
4.8.3 Resources controlled by:
The commands here are "Auto" or "Manual." Choosing "manual"
requires you to choose resources from each following sub-menu. "Auto"
automatically configures all of the boot and Plug and Play devices but
you must be using Windows 95 or above.
4.8.4 PCI/VGA Palette Snoop
This is left at "Disabled."
4.9 Password Setting
To change the password:
1. Choose the "Set Password" option from the "Initial Setup Screen"
menu and press <Enter>.
The screen will display the following message:
Please Enter Your Password
Press <Enter>.
2. If the CMOS is good or if this option has been used to change the
default password, the user is asked for the password stored in the CMOS.
The screen will display the following message:
Please Confirm Your Password
Enter the current password and press <Enter>.
3. After pressing <Enter> (ROM password) or the current password
(user-defined), you can change the password stored in the CMOS. The
password must be no longer than eight (8) characters.
Remember, to enable the password setting feature, you must first select
either "Setup" or "System" from the "Advanced BIOS Features" menu.
To Next Page
Loading...
