EKI-1361/EKI-1362 User Manual 26
3.3 Network Settings
This section explains how to configure the network setting of EKI device using this
utility so that it can communicate over a network with serial devices.
Click on the “+” before the model name, and the utility will expand the tree structure
to show the individual device name. And click on the “+” before the device name, and
the utility will expand the interfaces on this device server. Select the Ethernet
interface. (Select Eth1 or Eth2, these are two individual Ethernet ports)
MAC address:
The MAC address is for the local system to identify and locate each serial device
servers. This MAC address is already set before delivery from factory, hence no need
for further configuration.
IP address, Subnet Mask, Default Gateway:
You can choose from four possible IP Configuration modes --- Static, DHCP,
BOOTP, and DHCP/BOOTP.
To Next Page
Loading...