Advantech EKI-1528-DR - Port Configuration; Basic; Figure 6.4 Port Configuration > Basic

EKI-1500 Series User Manual 58
6.5 Port Configuration
The serial port configuration menu has Basic, Operation Mode, and Advanced Set-
tings.
6.5.1 Basic
The Basic menu allows for the configuration of the serial interface type, baud rate,
parity, data / stop bits, and flow control for port configuration.
To access this page, click Port Configuration > Basic.
Figure 6.4 Port Configuration > Basic
The following table describes the items in the previous figure.
Current Status
IP 1 Displays the current IP address 1 of the device.
IP 2 Displays the current IP address 2 of the device.
Save Click Save to save the values and update the screen.
Note! All new configurations will take effect after rebooting. To reboot the
device, click Tools > Reboot.
Item Description
Item Description
Type Click the drop-down menu to select a serial interface: RS-232,
RS-422, RS-485-2w or RS-485-4w.
Baud Rate Enter a value to specify the baud rate. The value should conform
to the current transmission speeds of connected devices when set-
ting the baud rate.
Parity Click the drop-down menu to select the parity: None, Odd, Even,
Mark or Space.
Data Bits Click the drop-down menu to select the data bits: 5, 6, 7, or 8.
Stop Bits Click the drop-down menu to select the stop bits: 1, 1.5 or 2.