EKI-1500 Series User Manual 56
6.2.2 Accessing the Web Page via Web Browser
Once the device is installed and connected, power on the device. The following infor-
mation guides you through the logging in process.
1. Launch your web browser on the PC.
2. In the browser’s address bar, type the device’s default IP address (Eth1:
10.0.0.1, Eth2: 10.0.0.2).
The main menu is shown.
6.3 System
You can change the Device Name and Device Description on this page. You can also
enable or disable the Telnet and SNMP functions. Moreover, you can set the Time
zone related settings.
To access this page, click System.
Figure 6.2 System
The following table describes the items in the previous figure.
Item Description
Firmware version Displays the current firmware version of the device.
Revision number Displays the revision number of the device.
Device Name Enter the device name: up to 31 alphanumeric characters.
Device Description Enter the device description.
VCOM Ignore Device ID Click Enabled or Disabled to enable or disable VCOM ignore
device ID.
Telnet Click Enabled or Disabled to set remote access through the Tel-
net Service function.
SNMP Click Enabled or Disabled to define the SNMP daemon.
Local Time Click Modify to set local date and time of the system.
To Next Page
Loading...
