EKI-1500 Series User Manual 76
7.3 Command List
7.3.1 system
Usage: system
Show current device status and informations.
Usage: system name [Maximum length 31 bytes]
Set current device name.
Usage: system desc [Maximum length 127 bytes]
Set current device description.
7.3.2 port
Usage: port [nn|all]
Show port status and informations.
Usage: port [nn] desc [Maximum length 127 bytes]
Set serial port description.
Usage: port [nn|all] type [232|422|485] flow []
Set serial port type and flow control.
– flow 0:None.
– flow 1:XOn/XOff.
– flow 2:RTS/CTS.
– flow 3:DTR/DSR.
Usage: port [nn|all] baud [50-921600] parity [] data [5-8] stop [1|1.5|2]
Set serial baud rate, parity and numbers of data bits, numbers of stop bits.
Acceptable baud: 50, 75, 110, 150, 300, 600, 1200, 1800, 2400, 4800, 7200,
9600, 14400, 19200, 38400, 57600, 115200, 230400, 460800, and 921600
– parity n: None Parity.
– parity e: Even Parity.
– parity o: Odd Parity.
– parity m: Mark Parity.
Command Function Description
system Show or configure the system information
port Show or configure the serial ports information
portadv Show or configure the serial ports advanced settings
mvcom Show or configure the serial ports in Virtual COM mode
mctrl Show or configure the serial ports in Control mode (USDG)
mdata Show or configure the serial ports in Data mode (USDG)
net Show or configure the Ethernet ports settings
password Set or change the password
alarm Show or configure the auto warning functions including mail alarm and
SNMP alarm
monitor Monitor the serial ports status
mrfc2217 Show all port modes and mode information.
apply Write settings to the flash memory and reboot the system immediately
exit Terminate the shell session
help Display command list help information
reboot Write settings and reboot the system immediately.
To Next Page
Loading...
