Advantech WISE Series - WISE-S672 I;O Module

19 WISE-4610(P) User Manual
Chapter 3 Hardware Specifications
3.5.3.2 Analog Input
 Channels: 2
 Resolution: 16 bit
 Sampling Rate: 1 Hz per channel
 Accuracy:
– ±0.1% of FSR (Voltage)
– ±0.2% of FSR (Current)
 Input Range: ±1 V, ±5 V, ±10 V, 0 ~ 1 V, 0 ~ 5 V, 0 ~10 V, 0 ~ 20 mA, 4 ~ 20 mA,
±20 mA
 Input Impedance:
– > 2 MΩ (Voltage)
– 120 Ω (External Resistor for Current)
 Isolation Voltage: 2000 VRMS
 Common Mode Voltage: 350 V
DC
 Drift:
– Unipolar: ±100 ppm
– Bipolar: ±50 ppm
 Burn-Out Detection: Yes (4 ~ 20 mA only)
 Supports data scaling and averaging
3.5.3.3 Digital Output
 Channel: 1 (Sink Type)
 Non-isolation
 Output Current: 100 mA
3.5.3.4 COM Port
 Port Type: RS-485
 Baud Rate (bps): 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
 Data Bits: 7, 8
 Stop Bits: 1, 2
 Parity: None, Odd, Even
 Flow Control: Auto flow control
 Signals: DATA+ and DATA-
 Protection: 15 kV ESD
 Supported Protocols: Modbus/RTU (Up to 128 addresses with a maximum of
30 instructions)
3.5.4 WISE-S672 I/O Module
3.5.4.1 Digital Inputs
 Channels: 6
 Logic Level (Dry Contact):
– 0: Open
– 1: Close DI COM
 Non-isolation
 Supports 32-bit counter input function (maximum signal frequency: 200 Hz)
 Supports keep/discard counter value when power OFF
 Supports frequency input function (maximum signal frequency: 200 Hz)
 Supports inverted digital input status