Service-Bulletin
DGS-TDS-N © Electrolux
29.03.05
599 522 030Washing machines EN
Toploader
The inlet valve does not close.
Cause: There may deposit waste particles in the inlet valve, depending on quality of water resp. of pipe
lines. The closing function cannot be guaranteed any longer because of that. Water is always
flowing in when the water tap is opened.
Measure: With washers having a connecting piece between inlet hose and valve, it is possible to
integrate an additional sieve, No. 146757600/3 into the connecting piece.
The retrofitting can be executed by removing the inlet hose at the appliance. Press the sieve
to the stop into the connecting piece. The customer can clean this sieve himself in case of a
pollution.
From series no. 452 ... this new sieve is installed at works.
To Next Page
Loading...
