5.4 The inlet hose
1. Connect the water inlet hose to the back of the appliance.
2. Position it toward left or right depending on the position of the
water tap.
Make sure that the inlet hose is not in vertical position.
3. If necessary, loose the ring nut to set it in the correct position.
4. Connect the water inlet hose to the cold water tap with 3/4"
thread.
WARNING!
The inlet water shall not exceed 25 °C.
CAUTION!
Make sure that there are no leaks from the couplings.
22/96
INSTALLATION
To Next Page
Loading...
