The indicator of the Start/Pause button flashes.
The display shows an indicative programme duration, the maximum
declared load for the set programme (only for a few seconds), the
default temperature, the default spin speed and the washing phase
indicators (when available).
2. To change the temperature and/or the spin speed, touch the
related buttons.
3. If desired, set one or more options by touching the related
buttons. The related indicators come on in the display and the
given information changes accordingly.
In case a selection is not possible, no indicator comes on and
an acoustic signal sounds.
11.5 Starting a programme
Touch the Start/Pause button to start the programme.
The related indicator stops flashing and stays on.
In the display, the indicator of the operating phase starts flashing.
The programme starts, the door is locked. The display shows the
indicator
.
The drain pump can operate shortly before the appliance fills
water.
11.6 Starting a programme with the Fertig In option
1. Touch this repeatedly until the display shows the desired time
within the programme should end. The indicator comes on.
2. Touch the Start/Pause button. The drum starts rotating to
perform the ProSense estimation, if foreseen in the selected
programme.
3. The appliance starts the countdown to the end of the programme
and the programme will start at the right moment for ending at
the time set through this option.
56/96
DAILY USE
To Next Page
Loading...
