13.11 Emergency drain
If the appliance cannot drain the water, carry out the same
procedure, described in 'Cleaning the drain pump' paragraph. If
necessary, clean the pump.
When you drain the water with the emergency drain procedure, you
must activate the drain system again:
1. Put 2 litres of water in the main wash compartment of the
detergent dispenser.
2. Start the programme to drain the water.
13.12 Frost precautions
If the appliance is installed in an area where the temperature can
reach the values around 0° C or drop below, remove the remaining
water from the inlet hose and the drain pump.
1. Disconnect the mains plug from the mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a container and let the water
flow out of the hose.
4. Empty the drain pump. Refer to the emergency drain procedure.
5. When the drain pump is empty, install the inlet hose again.
WARNING!
Make sure that the temperature is higher than 0 °C before you
use the appliance again.
The manufacturer is not responsible for damages caused by low
temperatures.
79/96
CARE AND CLEANING
To Next Page
Loading...
