EasyManua.ls Logo

AEG LR8E70480 - Water-Stop Device; Water Drainage

AEG LR8E70480
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Do not use an extension hose if the inlet hose is too short.
Contact the service centre for the replacement of the inlet hose.
5.5 Water-stop device
The inlet hose has a water stop device. This device prevents water
leaks in the hose because of its natural ageing.
The red sector in the window «A» shows this fault.
A
If this occurs, close the water tap and contact the authorized
service centre to replace the hose.
5.6 Water drainage
The drain hose should be positioned at a height of not less than 60
cm and not more than 100 cm from the floor.
You can extend the drain hose to maximum 400 cm. Contact the
authorized service centre for the other drain hose and the
extension.
It is possible to connect the drain hose in different ways:
1. Make a U shape with the drain hose and put it around the plastic
hose guide.
23/96
INSTALLATION

Table of Contents

Related product manuals