9. BEFORE FIRST USE
During installation or before first use you may observe some
water in the appliance. This is a residual water left in the
appliance after a full functional test in the factory to ensure the
appliance is delivered to customers in perfect working order and
is no cause for concern.
1. Make sure that all transit bolts have been removed from the
appliance.
2. Make sure that the electrical power is available and the water tap
is open.
3. Pour 2 litres of water into the detergent compartment marked by
.
This action activates the drain system.
4. Pour a small quantity of detergent into the compartment marked
by .
5. Set and start a programme for cotton at the highest temperature
without any laundry in the drum.
This removes all possible dirt from the drum and the tub.
39/96
To Next Page
Loading...
