The display shows the normal programme duration alternatively
with the set programme end time (expressed in hours 0h). The
minimum selectable time corresponds to rounded up hour of the
maximum duration of a programme (e.g. if the cycle duration lasts
3:15 hours, the minimum selectable time will be 4h).
After programme start, the door is locked and the appliance starts
the ProSense phase. When load estimation ends, on the display
the icon of running phase blinks and the time digit counts down in
steps of one hour and in steps of 1 minute during the last hour.
7.5 Start/Pause
Touch the Start/Pause button to start, pause the appliance or
interrupt a running programme.
7.6 Pods
Touch this button to activate or deactivate the Pods option .
When activated the relevant indicator is on.
Follow the Pods manufacturer's dosage and storage
recommendations.
Put maximum two tablets or single-dose detergents in the Pods
compartment in the detergent dispenser drawer.
The option remains active also for next cycles until it is deactivated
and if it is selectable with the set programme.
7.7 Plus Dampf
This option adds a steam phase followed by a short anti-crease
phase at the end of the washing programme.
The steam phase reduces fabric creasing and facilitates the fabric
ironing. The recommended maximum load decreases on the
display.
The indicator blinks on the display during steam phase.
This option can affect the programme duration.
32/96
DIAL AND BUTTONS
To Next Page
Loading...
