AEG LR8E70480 - End of the Programme; Draining Water out after End of Cycle

In the display the related door lock indicator goes off.
2. Open the appliance door. If necessary, add or remove the items.
3. Close the door and touch the Start/Pause
button.
The programme or the delay start continues.
When the icon goes off, the door can be opened when the
programme is complete, or set spinning or draining programme/
option and than press Start/Pause button.
11.12 End of the programme
When the programme has finished, the appliance stops
automatically. The acoustic signals operate (if they are active).
In the display all washing phase indicators become steady and the
time area shows .
The indicator of the Start/Pause button goes off.
The door unlocks and the indicator goes off.
1. Press the Ein/Aus button to deactivate the appliance.
After five minutes from the end of the programme, the energy
saving function automatically deactivates the appliance.
When you activate the appliance again, the display show the
end of the last selected programme. Turn the programme dial to
set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent dispenser slightly ajar to
prevent mildew and odours.
5. Close the water tap.
11.13 Draining water out after end of cycle
If you have chosen a programme or an option that does not empty
out the water of the last rinse, the programme is completed, but:
60/96
DAILY USE