2. SAFETY INSTRUCTIONS
2.1 Installation
The installation must comply with relevant national regulations.
• Remove all the packaging and the transit bolts including rubber
bush with plastic spacer.
• Keep the transit bolts in a safe place. If the appliance is to be
moved in the future they must be reattached to lock the drum to
prevent an internal damage.
• Always take care when moving the appliance as it is heavy.
Always use safety gloves and enclosed footwear.
• Follow the installation instructions supplied with the appliance.
• Do not install or use a damaged appliance.
• Do not install or use the appliance where the temperature can be
less than 0°C or where it is exposed to the weather.
• The floor area on which the appliance is to be installed must be
flat, stable, heat resistant and clean.
• Make sure that there is air circulation between the appliance and
the floor.
• When the appliance is in its permanent position, check if it is
levelled correctly with the aid of a spirit level. If it is not, adjust the
feet accordingly.
• Do not install the appliance directly above a floor drain.
• Do not spray water on the appliance and do not expose it to
excessive humidity.
• Do not install the appliance where the appliance door cannot be
fully opened.
• Do not put a closed container to collect possible water leakage
under the appliance. Contact the Authorised Service Centre to
ensure which accessories can be used.
9/96
To Next Page
Loading...
