When the programme stops the display shows a zero , the
indicator is steady on and the indicator starts blinking, and the
Start/Pause
led remains lit. The drum performs smooth
movements for about 30 minutes to keep the steam benefit. By
touching any button the anti-crease movements stop and the door
unlocks, the appliance proposes again the previous set
programme.
To interrupt the anti-crease phase, you can also:
• Press the Ein/Aus button for a few seconds to activate or the
deactivate the appliance.
• Turning the programme dial in another position.
An half laundry load helps to reach better results.
7.8 Extra Spülen
With this option you can add a few rinses to the selected washing
programmes and optimise the fabric softener distribution and
improve the fabric softness.
It is suggested when you use the fabric softener.
Useful for people allergic to detergents and in areas where the
water is soft.
This option increases the programme duration.
The button indicator comes on.
7.9 Zeit Sparen
With this option you can decrease the programme duration.
• If your laundry is normally or lightly soiled, it may be advisable to
shorten the washing programme. Touch this button once to
decrease the duration.
• In case of smaller load, touch this button twice to set an extra
quick programme.
In this case, the temperature 95°C is not selectable.
33/96
DIAL AND BUTTONS
To Next Page
Loading...
