4. If the end of the drain hose looks like this (see the picture), you
can push it directly into the stand pipe.
5. Without the plastic hose guide, to a sink spigot - Put the
drain hose in the spigot and tighten it with a clamp. Refer to the
illustration.
Make sure that the drain hose makes a loop to prevent particles
going into the appliance from the sink.
6. Position the hose directly to a built-in drain pipe in the room
wall and tighten it with a clamp.
5.7 Electrical connection
At the end of installation you can connect the mains plug to the
mains socket.
25/96
INSTALLATION
To Next Page
Loading...
