14
• The operating conditions and restrictions resulting from the technical
data are observed.
• Should abnormal voltages, noises, increased temperatures, vibra-
tion or similar occur, the device is immediately put out of operation
and the maintenance personnel is informed.
2.4 Personnel requirements
• Only qualified electro-technical personnel who are familiar with the
pertinent safety and installation regulations may perform the follow-
ing:
- transport
- installation
- connection
- commissioning
- maintenance
- testing
- operation.
• These operating instructions must be read carefully by all persons
working with or on the equipment prior to installation and initial start-
up.
2.5 Intended use
The device may only be used for the purpose for which it was inten-
ded, as persons may otherwise be exposed to dangers (e. g. electric
shock, burns) and plants also (e. g. overload). The user must therefo-
re observe the following points:
• It is not permitted to make any unauthorised modifications to the unit
or to use any spare parts or replacement parts not approved by AEG
PS, or to use the unit for any other purpose.
• The warranty obligations of the manufacturer are only applicable if
these operating instructions are observed and complied with.
• The device may only be used for control and regulation of electrical
power.
• The device is a component that cannot function alone.
• Project planning must account for the proper use of the device.
• Never exceed the maximum permitted connection values as given
on the type plate.
To Next Page
Loading...
Need help?
General
