AEG THYRO-A - Averaging for the Analog Output; Control Limits; Controller Parameters; Mains Load Optimization

35
EN
3.10.2 Averaging for the analog output
In order to attain a finer line thickness for line recorders, for example,
the output signal can be smoothened if needed to suit the applica-
tion.
MEAN 100 Mains periods (default setting)
3.10.3 Control limits
For operating modes TAKT and VAR, it is possible to set control limits
(end position limits).
For Takt
T
smax
Maximum switch-on period
T
smin
Minimum switch-on period
For VAR
V_IE Front pulse end position
H_IE Rear pulse end position
3.10.4 Controller parameters
The parameters of the controller can be adapted to the path if
needed.
Parameters
T
I
20 Controller I share
K
P
60 Controller P share
K
R
5 Controller amplification
* Default setting
3.10.5 Mains load optimization
The time for software synchronization can be set (see page 68, Mains
load optimization).
(50Hz) => Delay period after mains returns 10ms * 100 =
1000 ms
(60Hz) => Delay period after mains returns 8.33ms * 100 =
833 ms
(Default setting: 100)