AEG THYRO-A User Manual

48
For ...H1
When DIP switch S1.5 is at „ON“, the maximum load voltage (with
U/U
2
control) can be defined on potentiometer R201 TRAFO ADAPTI-
ON. The control characteristic curve is adapted in accordance with the
following equation: U
load max
= (No. of turns R201 : 9) * U
type
4.3.4 Setting maximum load current (only for...H RL1 and ...H RLP1)
The maximum load current is limited with potentiometer R203
CURRENT LIMIT, irrespective of the control mode. If there is no
I control, the potentiometer works as current limiter.
At reduced ambient temperatures, the power controller can only be
operated with up to 110% of its nominal current (effective value) (see
page 82, Technical Data).
Tab. 4 Maximum load value at control end
4.a Thyro-A 1A ,-A2A
4.b Thyro-A 3A
Setting U
load max
P*
1
load max
Potentiometer R202 Potentiometer R202
SCALE SETPOINT SCALE SETPOINT
Potentiometer turns 9 * U
load max
/ U
type
5.2 * P
load max
/ P
type
(from left stop)
Setting aid, analog 10mA * U
load max
/ U
type
5.77mA * P
load max
/P
type
output in mA
(Switch S1.10 = „OFF“)
Setting aid, analog 5V * U
load max
/ U
type
2.89V * P
load max
/ P
type
output in vols
(Switch S1.10 = „ON“)
Einstellung U
load max
P
load max
Potentiometer R202 Potentiometer R202
SCALE SETPOINT SCALE SETPOINT
Potentiometer turns 9 * U
load max
/ U
type
7.8 * P
load max
/ P
type
(from left stop)
Setting aid, analog 10mA * U
load max
/ U
type
8.66mA * P
load max
/P
type
output in mA
(Switch S1.10 = „OFF“)
Setting aid, analog 5V * U
load max
/ U
type
4.33V * P
load max
/ P
type
output in volt
(Switch S1.10 = „OFF“)

AEG THYRO-A Specifications

General

Brand	AEG
Model	THYRO-A
Category	Controller
Language	English