AEQ BC-2500
Radio Broadcast Mixing Desk
24
5.6. BC-2560-C STEREOPHONIC + SUM MONOPHONIC OUTPUT+INPUT BYPASS
MODULE
5.6.1. Functional description
The Stereophonic + Sum Monophonic + Input Bypass BC-2560-C output module performs
the function of combining all the inputs signals assigned to it and a switch allows the signal or
these signals combined, or and external input, to be sent to the output.
The normal use of this module is Master 1 output.
This switched output function permits, in the case of networks with chain programming, to
use their chain input, switchable directly with the output, to send this program in chain directly to
“air” and to free mixing console to carry out other functions.
The BC-2560-C can be programmed for connection to any of the output buses: Master 1,
Master 2, Auxiliary 1 and/or Auxiliary 2. This operation is performed during manufacturate. To alter
this specification consult section 7.1. It should be noted that two BC-2560-A modules must
never be connected to the same bus.
The output level is controlled by the slide fader (5). The monophonic output at connector
(6) MONO OUTPUT, together with the stereo output at connector (7) OUTPUT (L) and (8)
OUTPUT (R) corresponding to the left and rigth channels respectively are delivered to the output.
The external chain signal input enters by connector (9) EXT INPUT (L) and (10) EXT
INPUT (R) and is activated by switch (2) BYPASS NETWORK. The input gain is controlled by
potentiometer (1) NETWORK LEVEL and a push-button (4) PFL NETWORK to send to pre-listen
bus, the status is reflected by the illumination of the led (3) PFL NETWORK.
To Next Page
Loading...
Need help?
General
