06/05/13 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 • Ph: 800-526- 0288 Page 3 of 112
Table of Contents
Table of Contents .......................................................................................... 3
1. INTRODUCTION ................................................................................ 7
1.1 Safety and Warnings ........................................................................................ 7
2. E8 CONTROLLER AND BCM DESCRIPTION ..................................... 9
2.1 E8 Controller Features And Functions ........................................................... 9
2.2 BCM Features And Functions ....................................................................... 10
3. E8 CONTROLLER OPERATION ....................................................... 11
3.1 NORMAL Mode Operation (Door Closed)..................................................... 11
3.1.1 NORMAL Mode Display Functions ................................................................... 11
3.1.2 HEATING Mode Selection (in NORMAL Mode) ............................................. 12
3.1.3 MENU Mode Operation (Door Open) ................................................................ 12
3.2 Software Menus .............................................................................................. 13
3.2.1 Basic Menu/Sub-Menu Navigation and Selection .............................................. 15
3.2.2 Basic Parameter Navigation, Selection, and Revision ........................................ 16
4. E8 CONTROLLER MENUS AND SUB-MENUS ................................. 17
4.1 DISPLAY Menu ............................................................................................... 18
4.2 USER Menu ..................................................................................................... 21
4.3 TIME PROGRAM Menu and Sun-Menus ....................................................... 24
4.4 EXPERT Menu and Sub-Menus ..................................................................... 25
4.4.1 Available V-Curve Preset Voltage Curves for 0 – 10 Volt Input ....................... 31
4.5 EXPERT HS Menu (Not Used) ...................................................................... 31
4.6 GENERAL Menu ............................................................................................. 32
4.6.1 DATE / TIME Menu ........................................................................................... 32
4.6.2 SERVICE Menu .................................................................................................. 34
4.7 E8 Controller Initial Startup ........................................................................... 37
4.7.1 CAP/MODULE Function (Maximum Kilowatts per Burner) ............................ 39
4.7.1 Available Settings for Relay Functions 1 – 4 ...................................................... 40
5. E8 OPERATING MODE: Set-up and Programming ............................. 42
5.1 Indoor/Outdoor Reset Mode .......................................................................... 42
5.1.1 Wiring Connections............................................................................................. 42
5.1.2 Indoor/Outdoor Reset Operation Configuration ................................................. 42
5.1.3 Viewing the Boiler Setpoint ................................................................................ 44
5.2 Constant Set Point Mode ............................................................................... 44
5.2.1 Wiring Connections............................................................................................. 45
5.2.2 Constant Setpoint Mode Configuration............................................................... 45
5.2.3 Viewing Constant Set Point ................................................................................ 45
5.2.4 Configuring Set Point High and Low Limits Per Outside Temperature Sensor . 45
To Next Page
Loading...