EN
11_11. 6755532_02
1. Machinery Directive
2006/42/CE
2. Low Voltage Directive
LVD 2006/95/CE
3. Electromagnetic compatibility
Directive EMC 2004/108/CE
4. Pressure Equipment Directive
PED 97/23/CE, EN 378,
5. UNI12735, UNI14276
1.
2.
1. ISO DIS 9614/2
intensimetric method
IP24
EUROVENT
Questa unità contiene gas floururali a
effetto serra coperti dal protocollo di
Kyoto. Le operazioni di manutenzione
e smaltimento devono essere eseguite
solo da personale qualificato, nel rispet-
to delle norme vigenti
DANGER!
The refrigerant circuit is under pressure.
Moreover, very high temperatures an be
reached. The appliance may only be pe-
ned by an SAT service technician or by a
qualified technician.
Work on the cooling circuit may only be
carried out by a qualified refrigeration
technician.
The cooler comes supplied with a
ufficient quantity of R410A refrigerant
gas. This refrigerant is chlorine-free
and does not damage the ozone layer.
R410A is not flammable. However,
all maintenance operations must be
carried out exclusively by a specialised
technician using suitable protective
equipment
Before opening the heat pump, comple-
tely disconnect the appliance from the
power mains.
AERMEC ANK are constructed according to the re-
cognised technical standards and safety regulations.
They have been designed for air conditioning and
must be destined to this use compatibly with their
performance
features. Any contractual or extracontractual liability
of the Company is excluded for injury/damage to
persons,
animals or objects owing to installation, regulation
and maintenance errors or improper use. All uses
not expressly indicated in this manual are prohibited
1.
of the system, who assumes the responsi-
they are always at hand in case of need
.
2. L
of all works must be performed by quali-
3. The appliance must be installed in such
a way as to enable maintenance and/or
repairs to be carried out
.
4. The appliance warranty does not cover
necessary for carrying out servicing under
warranty
.
5. Do not modify or tamper with the chiller
and the manufacturer will not be liable
for any damage caused. The validity of the
warranty shall be void in the event of fai-
.
1. The chiller must be installed by a qualifi ed
and suitably trained technician, in compliance
with the national legislation in force in the
country of destination.
AERMEC will not assume any responsibility
for damage due to failure to follow these
instructions.
2. Before beginning any operation, READ THESE
INSTRUCTIONS CAREFULLY AND CARRY OUT
THE SAFETY CHECKS TO REDUCE ALL RISK
OF DANGER TO A MINIMUM. All the staff
involved must have thorough knowledge of
the operations and any dangers that may
arise at the moment in which the installation
operations are carried out.
To Next Page
Loading...
