EN
11_11. 6755532_02
Before beginning installation consent with client and
pay attention to the following recommendations:
1. The support surface must be capable of sup-
porting the unit weight;
2. The safety differences between the unit and
ther appliances or structures must be scrupu-
lously respected so that the inlet and outlet
AIR from the fans is free to circulate;
3. The unit must be installed by an enabled
technician in compliance with the national le-
gislation in force in the country of destination,
respecting the minimum technical spaces in
order to allow maintenance.
17.2.1. POSITIONING
Before handling the unit, verify the lifting capacity of
the machines used, respecting the indications given
on the packaging.
To handle the machine
on horizon-
tal surfaces, se fork lift trucks or similar in the most
appropriate manner, paying attention to the distribu-
tion of the unit weight.
The length of the pipes must be such to allow posi-
tioning of the lifting belts and relative safety pins.
Position the unit in the place indicated by the
customer, placing a rubber covering between the
further information, refer to the dimensional tables
Fix the unit checking that it is level. Make sure that
the hydraulic and electric part can be easily reached.
In case of installation in places where gusts of wind
are frequent, fix the unit suitably using tie-rods.
Envision the installation of the condensate drain tray
500mm
20in
200mm
8in
300mm
12in
500mm
20in
200mm
8in
300mm
12in
To Next Page
Loading...
